Tyco Electronics unveils new LED lamp connector

Tyco Electronics, an electronics component provider, has launched a new "plug in" plug in connector. The product is mainly used in lighting control and LED lighting module (such as the LED lamp), so that the aluminum based printed circuit board connection between the more simple and quick. Tyco Electronics new LED lamp connector once again fully verify the powerful R & D and innovation strength Tyco Electronics, lighting industry to meet the needs of the internet.

Tyco Electronics launched the connector shape is simple, the use of SMT surface mount design, and supports 2, 4 and 6 jack. The connector is designed with a "non - polarity chip plug", which is more flexible than the traditional plug in connection with the LED printed circuit board. When the connection is carried out, only two circuit boards can be slid horizontally or vertically. Vertical slip is a unique feature of the product, in the replacement of the LED lighting strip in the middle of the circuit board, as long as the replacement of the plate up, and then press down into the new board, the operation is very convenient.

Not only that, the new connector with Tyco Electronics also has flexible way, support level and vertical shift 2.5 mm 1.1 mm, in order to adapt to the change of the installation of printed circuit board may, with the support and right angle type.

The use of non-polar design has the following advantages:

Only count the number of a model when registering the inventory;

The same pads can be used at both ends of the plate, which simplifies the design of the circuit board.

Tyco Electronics new LED lamp connector has a liquid crystal polymer shell, and has a reel packaging, can be used with vacuum and reflow soldering equipment. The height of the connector is only 3.9 mm, the appearance is very small. The rated current of the product is 6A, and the material is fully in accordance with the RoHS specification.