How to install the LED lamp to achieve the effect of the lamp slot is very good? (two)

So, how should install, in order to avoid this "not far" problem? Simple geometry can know: lamps with a mounting height of a little higher, can make the light shielding away from the lamp groove, light can "zhaoyuan".

Figure: lamp with height and light shading plate groove is almost flush away from light shading lines, "zhaoyuan". You don't have to worry about who will see the lamp with the lamp.

Moreover, this installation is more convenient for workers to screw the screws, you say is not it?

This installation, the utilization rate of light is also higher than the above, there are more luminous flux output to the ceiling. However, even so, there are half of the light in the slot to block out the light, if the light with a certain bias with its own light, it is more perfect ~ there are two kinds of polarization.

Figure: light with a slight dip angle, can be used to improve the utilization rate of light. This method requires manufacturers to provide tilt mount bracket base, there is no standard products, generally need to customize.

Figure: the lamp comes with a polarizing lens, can greatly improve the utilization of light, projection distance will be further. This method has only one drawback...... Too expensive.

The above said, "according to the situation," that "out" that is how it?

Figure: this effect occurs, it is clear that the wrong installation of the lamp belt, as well as before the installation of the workers as well as the lamp holder"......

Then...... Sawtooth effect?

The production of the sawtooth is generally the use of hard light strip, in the slot placed in the wrong. Just pay attention to the installation position, let the light from the lamp slot. Even if a bit misplaced, it will not produce obvious jagged. Of course, now the soft light flux is also getting bigger and bigger, the use of hard light is also less.

In front of what we say is the situation of the ceiling, and there is a situation in the light of the wall, and how to consider it? Look at a counterexample:

Figure: like the installation of the ceiling, the wall will form a perfect line".

Figure: wash wall lamp should be installed, this time, you must have found: the vertical groove of the lamp is actually no longer needed, ha ha ~ ~ ~ what? See the light? OK Who will look up at the wall? In addition to you and me, "occupational disease lighting".

Figure: in accordance with the above installation of the wall lamp, it should be noted that the wall can not have specular reflection, otherwise there will be the effect of this map: the light is washed down, but people will see the light in the following article.

So the question is: the mirror wall, how should I do?

At this point, can only sacrifice the efficiency of light utilization, the use of diffuse reflection or diffuse ~ ~

Figure: diffuse reflection lamp light out of the map. The picture of the tube bracket is not T5 fluorescent lamp Oh, but it is recommended that you use the LED lamp bracket.

Figure: diffuse through the spotlight light map. Figure in the location of the proposed placement of light blue frosted acrylic sheet.

Finally, this figure, to the hotel's interior designers, when you worry about the mirror stone floor, if you do luminous anchor line, this method can help you solve the problem. Look at this piece of drawing, is not see light suddenly?

Figure: This is a model of Taiwan, a circle around the anchor lights, interior design is the original lamp with direct exposure to the ground, the mirror can see a marble reflective beads, feeling very low yeah

Figure: This is my adjusted drawing, an increase of diffuse transmission machine, don't have to worry about a see, ha ~

The installation of a variety of lights are almost the same, and finally sum up, if you encounter a more special situation, you need to use your intelligence, to think about a few things:

Where is the shading line? Will it be obvious?

In the normal walk, will not see the light?

It is not a mirror material will see reflective beads?