Pool lighting design LED lamps to consider what? (two)

For different widths of rectangular swimming pools, the required luminous flux of the LED luminaire is as follows:

The use of the wire must be a special underwater wire, and can be specified by the manufacturer of copper core diameter matching. If the lamp does not have a wire (in order to have a more flexible wire length), make sure to follow the manufacturer's recommendations to seal the connection. The junction box and the watertight sealing system shall also be required.

Ideally, the connection between the wire and the lamp will be completed at the lamp factory, which requires the length of the wire to be determined when the lamp is placed. For the values listed above, the lighting effect is more obvious in the water, it is recommended that the swimming pool environment is maintained below 100lx. For rectangular swimming pool, if you want a more uniform illumination, the lamp is recommended to be installed on both sides of the long side, 90 degree beam angle, lamp spacing about half of the pool width.

Maintenance of the pool is often required to lower the water level or empty the water in the pool, but the need for the end users of the pool to be noted is that many high-power LED lamps need water to help cool.

All in all, the design of a pool of light, a high degree of lighting requirements, the need for good lighting quality, light flux, size, color, color temperature, beam angle and so on need to match.