See how Japanese lighting designers design LED lighting (five)

Adjust the light is the last indispensable process

Installation of lighting fixtures, on-site lighting confirmation. In the lighting layout of the project, the lighting engineering layout of the location of the layout of the lamp to check the significance of the layout, whether in accordance with the design requirements. It was a good thing to be able to confirm that the lamp was lit, but it was often considered redundant. However, the residential lighting installation height or position, even if the difference is 10cm, will also bring a small change in the space impression and room atmosphere, resulting in the lighting can not achieve the desired results. Therefore, the lighting designer in the completion of the scene to examine the lighting effect and the design phase of the image content of the number of differences.

The lighting lamp has a fixed mounting type and a non fixed mounting type. In addition, the lamp can be adjusted to change the angle of the light, the scattering, the brightness and the like after the installation. General like that fixed type lamps downlight, once installed, the lamp is not moving. But, like the adjustable and eyeball shaped like downlight, is the illumination direction can be adjusted to change the lighting. In addition, as the table lamp and slide type spotlights because it is not fixed, there are sockets and slides, so that anyone can simply move.

In order to make the space atmosphere and lighting effects close to the design of the image, adjust the light is very necessary. This includes focus and calibration, are very important in the design management. Shops, galleries, hotels and other multi use lamp, adjustable type lamp, and program dimming equipment is introduced, is not the lack of focus on. Light shines on the painting, foliage plants, commodities, etc., it will be in the space of the United States revealed, compared with before the focus is completely different scenery, of course, it is necessary. Therefore, the importance of residential performance in the room is also the use of non fixed installation lamps.

Finally, after the confirmation of the customer, to shoot the scene. As far as possible the measured illuminance of the data, as the next work reference. The best is to clean the lighting lamps and lanterns, lamp replacement and other necessary maintenance information to clients, poor maintenance will lead to shortened life lighting effect.

Concluding remarks

The above is the design process of the Japanese lighting designer may be able to have a certain reference value for the future design of our lighting designers.