Can drive a variety of LED bulbs, Renesas exhibited 6 models equipped with LED driver IC evaluation board

Renesas electronics developed with LED driver IC "R2A20134" led control circuit evaluation board "R2A20134EVBLED", and in Tokyo have held that the International Convention and Exhibition Center "TECHNO-FRONTIER 2011" and "twenty-sixth power system exhibition" on the show (exhibition area 3U-209). Renesas said the board was "R2A20134 development support tool".

R2A20134 is a LED bulb used inside the IC, from December 2010 to start listing. According to the power system exhibition exhibition commentator introduced in the high side of the MOSFET is the biggest feature of this IC. Therefore, the use of low-cost MOSFET (pressure 500V ~ 300V). In the low side of the need to install more than 700V high pressure MOSFET.

In the exhibition display evaluation board Photography: Tech-On!.

The R2A20134EVBLED a total of 6 products, can be applied to a variety of LED bulbs. In the use of the transformer insulation structure or the use of coil insulation structure, whether or not to support the three terminal triac switch light and control methods and other aspects of the 6 products are different. In addition to this assessment itself, is also bundled with instructions for use, including the evaluation board evaluation data and parts list, manual, and external constant set tool.

Renesas released data show that by the introduction of the assessment board, in 2014 will increase the output of R2A20134 to 10 million per month. At the December 2010 press conference, Renesas announced production scale in the production of 3 million per month in March 2011.